The dispensing machine maintenance requirements are basically the same, but also some differences. According to the different glue, there will be some differences. Today, I'd like to talk about the experience of dispensing maintenance of anaerobic dispensing machine, which can improve the service life of anaerobic dispensing valve and machine! And in this way, the production cost can be reduced!

　　Anaerobic glue dispenser generally uses some glue that is difficult to clean, such as 502, screw glue, etc. the cleaning time should also be grasped, because after the glue solidifies, it can no longer be cleaned, and it is also very troublesome to replace. It needs to replace the whole pivot point glue valve, which is different from other glue. Here, the cleaning rhythm must be paid attention to, so as to ensure the anaerobic glue dispensing valve and anaerobic glue Dispensing machine can be used continuously.

　　1. Anaerobic glue and 502 are special glue, and the material of anaerobic glue dispensing valve is Teflon, which will not react with glue. Using anaerobic glue will have a relatively long cleaning time, while 502 glue needs to be cleaned immediately and can be cleaned with alcohol.

　　2. There are also some tips for using the pressure barrel. Put a plastic cup in the pressure barrel, put the glue into it, and then put it on for dispensing.

 

　　The above is the experience of dispensing maintenance and the use of anaerobic glue dispenser, which can solve many problems. The pressure bucket is also convenient to use, does not need to be cleaned, and is not so troublesome to use, and is good for the pressure bucket. 502 glue can not be used when it is glued to the pressure bucket. Pay attention to the use of the pressure bucket to avoid cost expenditure.