Are you still worried about dispensing as a consumer? Are you still using manual dispensing? Manual dispensing not only wastes raw materials, but also has a bad effect. It often wastes a lot in maintaining a clean shell. Have you ever thought of replacing manual operation with mechanical operation? Full automatic dispensing machine with timely and quantitative dispensing can make your products look neat and do not waste raw materials. The glue is put into the glue storage bucket. The hand does not need to touch the glue, which is efficient and convenient. The appearance of dispensing machine improves consumption efficiency and product quality.

 

In the setting time of dispensing machine, the injector piston of dispensing machine is used to push out the liquid contained in the dispensing machine injector under low pressure environment or to control the pedal switch of automatic dispensing machine. The automatic dispensing machine can adjust the manual and semi-automatic forms sensitively. Automatic dispensing machine uses high precision digital controller to precisely control the time of every drop of glue to milliseconds on time. Precision control of liquid flow will never waste liquid substances. As long as the air pressure, time and needle tip of dispensing machine are selected correctly, and then the amount and time of each drop are reversed at will, this dispensing machine is superior to manual operation model. Type.

 

The dispensing machine can handle many glue droplets. It is simple, fast and easy to operate. It has the ability of vacuum suction. It can control the liquid with different viscosities and avoid dropping. Fully automatic dispensing machine is not easy to fatigue, no waste, widely used, complete set of products, reliable. According to the needs of users, syringes and a variety of dispensing machine consumables are equipped. From the matters needing attention when dispensing with automatic dispensing machine, we can see that the setting of self-control dispensing quantity and dispensing time has an impact on the quality of dispensing machine, so we must run the test before dispensing.

 

The deterioration of glue processing quality is one of the main reasons affecting the quality of dispensing machine: there must be no air bubbles when glue is on dispensing machine, a small air bubbles will form many places without glue coverage, forming the problem of glue wire drawing. For faulty products, the joint must be cleared when the hose is replaced halfway. As for the curing manufacturer of glue, the temperature curve has been given. In practice, we should adopt and adjust temperature curing as many times as possible to make the glue have enough strength after curing.